TOP

CHONGQING HUA TIAN HAO LI MACHINERY LLC

CHONGQING HUA TIAN HAO LI TRADING CO.,LTD

Chongqing Hua Tian Hao Li Machinery&Trading Co.,Ltd. Was established in 2005, and is located in Economic Techcal Development Area of Jinkou Town, Shapinba District, 


Phone:

+86-023-65180060
 


E-mail:

info@cnhthl.com
 


ADD:No,59-3 17-4,Nanxi Economic Area,Shapingba District, Chongqing,

© 2019 Chongqing, China Tian Hao plow Trading Company. All Rights Reserved. 

渝ICP备16005799号  Powered by:www.300.cn chongqing

——  NEWS CENTER

>
News
>
>
Processing method for each component of tillage machine

Processing method for each component of tillage machine

Classification:
Industry News
Author:
Source:
2019/07/17 11:07
Page view
[Abstract]:
1)depthcontrolsystemistocontrolthemicrofarmingoperationcontrolsystemandthespeedofdeepplowing.Mainlybytheresistanceoftheknife,theresistanceoftillageknifeholder,theresistanceofthehingeseat.Commonfaultsa
  1) depth control system is to control the micro farming operation control system and the speed of deep plowing. Mainly by the resistance of the knife, the resistance of tillage knife holder, the resistance of the hinge seat. Common faults are: resistance to the knife deformation caused by the forward direction of operation out of control.
  2) the clutch system of micro tillage machine is relatively simple, it is through the belt tension and slip to control the transmission. Mainly composed of a belt drive system, tensioner, tensioner, tensioner spring cable, tensioning wheel handle, belt guard. Common fault: belt is loose cause cannot drive, belt is too tight or belt cradle not in the proper position caused by transmission can not be separated from.
  3) transmission system mainly by the belt transmission, the gear transmission, the chain transmission components. Common failures are: belt wear, chain wear, etc..
  4) micro tillage plowing cutter is micro tillage machine normal work key tools and farming tools rational selection and use of the direct relationship to the quality of the efficiency and the effect of tillage farming.
  5) gear switching system consists of forward and reverse. Mainly consists of gear shift shifting fork, shift gear, shift lever positioning spring and positioning steel ball, gear indicator, and shift lever. Common faults are: variable gear shaft pin down causing variable gear failure. Http://www.hthlwgj.com/
  6) speed control system is mainly composed of throttle cable, throttle operating handle, throttle operation combination. Common faults are: accelerator operation handle screw loose caused by runaway speed.